The small push button fitting made of aluminum for handlebars with 1 inch or 22 mm (7/8 inch) tube diameter in the elaborately manufactured contrast cut.

The mo.switch mini is a universal, small push-button fitting for handlebars with a 1 inch or 22 mm (7/8 inch) tube diameter with an attractive look.

Very small and narrow but very striking thanks to the elaborate contrast cut. The housing, which is milled from solid material, is first anodized and then milled over at the edges.

3 miniature buttons with a defined pressure point are embedded in recesses that provide the thumb with the necessary orientation. The push-buttons are protected against splash water and are very robust.

Also, the individual strands are already soldered ready for use and waterproof cast. Only a hole for the thin cable must be drilled in the handlebar. With two meters of cable length, there are enough reserves for installation.

The two halves of the housing are screwed against each other with two stainless steel screws and fit handlebars with 22 mm or 1 inch diameter.

The case is also available polished. Then of course without the contrast look. If there is not enough space for a mo.switch mini on the right side of the handlebar due to a large throttle grip, two button housings can also be mounted on the left grip. The six buttons and the symmetrical milling create a special eye-catcher.

The mo.switch mini forms a super stylish handlebar look with the mo.grip aluminum grips or the mo.grip soft rubber grips as well as the mo.blaze disc handlebar end turn signal and the mo.rear rear view mirror. This modular and high quality handlebar grips turn signal system adorns the cafe racer as well as any other handlebar.

Used in conjunction with an electronic push button control (not included), these beautiful CNC machined fittings can switch all electrical units such as lights, turn signals, electric starter, horn and much more.